Moxa ONCELL G2110-T Bedienungsanleitung PDF herunterladen (Seite 14)

OnCell G2100 Series User’s Manual Getting Started

2-5

SIM Card Installation

In order to protect the SIM card, the SIM card slot is located inside the casing. You will need to

unscrew and remove the outer cover before installing or removing the SIM card.

OPEN

PRESS LOCK

SIM Cover

Follow these steps to remove or install the SIM card:

1. Unscrew the outer cover.

2. Slide the outer cover to the left to remove it.

3. Slide the SIM card cradle to the left and pull it towards you. Insert the SIM card into the

cradle.

4. Swing the cradle back against the unit and slide it back into place. Replace the outer SIM

card cover.

ATTENTION

The SIGNAL LEDs on the front panel provide a convenient way of checking if the SIM card is

installed properly. One of the three SIGNAL LEDs should remain on as long as the antenna is

installed and the network is operating normally. If none of the SIGNAL LEDs are on, then the

SIM card may not be installed properly. Since the PIN code is stored on the SIM card, the modem

will not be accessible from the cellular network if the SIM card is not installed correctly.

DIN-Rail Mounting

Built-in mounting appendages allow the modem to be mounted to a flat wall or on a DIN-rail.

Follow the intructions below to mount the modem on a DIN-rail.

ATTENTION

Before mounting the OnCell G2100 Series modem, we strongly recommend that you first remove

the antenna connection.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 104 105

Keine Kommentare

Moxa ONCELL G2110-T Bedienungsanleitung Seite 14