Moxa NPORT 5110-T Bedienungsanleitung PDF herunterladen (Seite 39)

NPort 5100 Series Web Console Configuration

5-16

ATTENTION

Inactivity time is ONLY active when

“TCP connect on” is set to “Any character.”

Ignore jammed IP

Setting Factory Default Necessity

No or Yes No Optional

Previously, when Max connections > 1, and the serial device is transmitting data, if any one of the connected

hosts is not responding, it will wait until the data has been transmitted successfully before transmitting the

second group of data to all hosts. Currently, if you select Yes for “Ignore jammed IP,” the host that is not

responding will be ignored, but the data will still be transmitted to the other hosts.

Packing length

Setting Factory Default Necessity

0 to 1024 0 Optional

Default = 0, The Delimiter Process will be followed, regardless of the length of the data packet. If the data

length (in bytes) matches the configured value, the data will be forced out. The data length can be configured

for 0 to 1024 bytes. Set to 0 if you do not need to limit the length.

Delimiter 1

Setting Factory Default Necessity

00 to FF (hex) None Optional

Delimiter 2

Setting

Factory Default

Necessity

00 to FF (hex) None Optional

Once the NPort 5100 receives both delimiters through its serial port, it immediately packs all data currently in

its buffer and sends it to the NPort 5100’s Ethernet port.

ATTENTION

Delimiter 2 is optional. If left blank, then Delimiter 1 alon

e trips clearing of the buffer.

If the size of the serial

data received is greater than 1 KB, the N

Port 5100 will automatically pack the data and send it to the Ethernet.

However, to use the delimiter function, you must at least enable Delimiter 1. If Deli

miter 1 is left blank and

Delimiter 2 is enabled, the delimiter function will not work properly.

Delimiter process

Setting Factory Default Necessity

Do nothing,

Delimiter +

1, Delimiter + 2, Strip

Delimiter

Do Nothing Optional

[Delimiter + 1] or [Delimiter + 2]: The data will be transmitted when an additional byte (for Delimiter +1), or

an additional 2 bytes (for Delimiter +2) of data is received after receiving the Delimiter.

[Strip Delimiter]: When the Delimiter is received, the Delimiter is deleted (i.e., stripped), and the remaining

data is transmitted.

[Do nothing]: The data will be transmitted when the Delimiter is received.

Force transmit

Setting Factory Default Necessity

0 to 65535 ms

0 ms

Optional

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 93 94

Kommentare zu diesen Handbüchern

Keine Kommentare

Moxa NPORT 5110-T Bedienungsanleitung Seite 39

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Serielle Server Moxa NPORT 5110-T