Moxa NPORT 5110-T Bedienungsanleitung PDF herunterladen (Seite 48)

NPort 5100 Series Web Console Configuration

5-25

If data received through NPort 5100’s Ethernet port is sent using the “enter” command, the data will be

transmitted out the serial port with an added

1. “carriage return + line feed” if you select the <CR-LF> option

(i.e., the cursor will jump to the next line, and return to the first character of the line)

2. “carriage return” if you select the <CR> option

(i.e., the cursor will return to the first character of the line)

3. “line feed” if you select the <LF> option.

(i.e., the cursor will jump to the next line, but not move horizontally)

Disabled Mode

When Operation mode is set to Disabled, that particular port will be disabled. Check the “Apply the above

settings to all serial ports” to apply this setting to the other port.

Accessible IP Settings

The NPort 5100 uses an IP address based filtering method to control access to itself.

Accessible IP Settings allows you to add or block remote host IP addresses to prevent unauthorized access.

Access to NPort 5100 is controlled by IP address. That is, if a host’s IP address is in the accessible IP table, then

the host will be allowed to access the NPort 5100. You can allow one of the following cases by setting the

parameter.

• Only one host with a specific IP address can access the NPort 5100

Enter “IP address/255.255.255.255” (e.g., “192.168.1.1/255.255.255.255”).

• Hosts on a specific subnet can access the NPort 5100

Enter “IP address/255.255.255.0” (e.g., “192.168.1.0/255.255.255.0”).

• Any host can access the NPort 5100

Disable this function by un-checking the “Enable the accessible IP list” checkbox. Refer to the following

table for more configuration examples.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 93 94

Keine Kommentare

Moxa NPORT 5110-T Bedienungsanleitung Seite 48